HPE Storage Users Group https://www.3parug.com/ |
|
7200c adding new drive enclosure M6710 https://www.3parug.com/viewtopic.php?f=18&t=3074 |
Page 1 of 1 |
Author: | o5k [ Mon Jan 07, 2019 5:57 pm ] |
Post subject: | 7200c adding new drive enclosure M6710 |
Hi, I already have 3PAR 7200C with one M6720 connected like in cable guide. Both DP-1 from drive enclosure are connected to DP-2 on both nodes. Now I need to add M6710. Do you think I can connect it from both DP-1 of M6710 to both DP-1 on nodes so I wil end up like on page 16 in this cable guide https://support.hpe.com/hpsc/doc/public ... =c04441597 but in my case E1 will be M6720 and E2 M6710? I would like to avoid re-cabling it since there is no guide how to do it online. Best regards |
Author: | cali [ Tue Jan 08, 2019 5:09 pm ] |
Post subject: | Re: 7200c adding new drive enclosure M6710 |
Yes, that's the correct way. Can be done Online. Add Disk license if you haven't reached 48 Drives at first. Remember that one Cable is short and other long, as the Guide describes. Insert Drives and power on the Shelf a while before connect. Execute admithw, after connect. |
Author: | o5k [ Fri Jan 11, 2019 4:43 am ] |
Post subject: | Re: 7200c adding new drive enclosure M6710 |
Thanks Cali. Sadly afted cabling I stucked at: checkhealth -svc -detail Cabling cage2 Check connections or replace cable from (cage0, node0, DP-1) to (cage2, I/O 0, DP-1) - failed links So i didn't admithw yet I switched SAS cable to new one. Problem persist. Only 3 leds out of 4 on bad SAS port in enclosure are on. In the output I see: Link_Speed(DP1,DP2) Unknown,Unknown 6.0Gbps,Unknown should be Link_Speed(DP1,DP2) 6.0Gbps,Unknown 6.0Gbps,Unknown cm3par cli% showcage -d cage2 Id Name LoopA Pos.A LoopB Pos.B Drives Temp RevA RevB Model FormFactor 2 cage2 1:0:1 1 0:0:1 1 16 24-26 4078 4078 DCS2 SFF -----------Cage detail info for cage2 --------- Position: --- Interface Board Info Card0 Card1 Firmware_status Current Current Product_Rev 4078 4078 State(self,partner) OK,OK OK,OK VendorId,ProductId HP,DCS2 HP,DCS2 Master_CPU No Yes SAS_Addr 50050CC1193CC73E 50050CC1193CC77E Link_Speed(DP1,DP2) Unknown,Unknown 6.0Gbps,Unknown Locate Off Off I created ticket to HPE and waiting. Will share leter about progress. |
Author: | o5k [ Thu Jan 17, 2019 6:25 am ] |
Post subject: | Re: 7200c adding new drive enclosure M6710 |
Ok to close this topic. Ended with node0 replace by HPE. |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |