HPE Storage Users Group https://www.3parug.com/ |
|
Not complete Cabaling and power on https://www.3parug.com/viewtopic.php?f=18&t=696 |
Page 1 of 1 |
Author: | chanchon [ Mon May 05, 2014 2:32 am ] |
Post subject: | Not complete Cabaling and power on |
Hi dears New 3PAR 7400 4 Node assembled on a rack . interconnect cables between Enclosures has been done But nothing doing about interconnect cables between Nodes (A & C). Today an idiot powered on all enclosures and Nodes(even not correct order) . consider No configuration.(Nothing till now) Now what do i have to do ? - power off all enclosures , complete cabling and powering on in correct order or - while it is powering on , attach cabling between interconnect Nodes and complete cabling (Not powering off) Any suggestion ? (please DO NOT consider calling HP) |
Author: | hdtvguy [ Mon May 05, 2014 5:49 am ] |
Post subject: | Re: URGENT***Not complete Cabaling and power on****URGENT |
I am not expert, but I don't think it is a huge deal, nothing is configured yet. At worst case the nodes will have a bunch of alerts. 2 options are wait for HP to get onsite and then have them serial in and cleanly shut down nodes or just power off. |
Author: | Brewer [ Tue May 06, 2014 3:18 am ] |
Post subject: | Re: URGENT***Not complete Cabaling and power on****URGENT |
If the 7400 has no configuration (OOTB has not been run) then you can power it off, re cable, power on and run OOTB. |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |