I figured out the problem. The policy "path_management" was not set on this remote copy group. I have to wait until the weekend to actually apply the change and test it, but all of my other remote copy groups are working correctly and they have the policy applied. Here is a paragraph from the HP remote copy user manual explaining more about this setting:
http://h20565.www2.hp.com/hpsc/doc/publ ... -c03618143"
If path_management is not enabled, the ALUA state of all exported volumes is set to ACTIVE.
Both source and target replication volumes are accessible to the host cluster, and host access must
be controlled at the host level.
Should an ESX host become disconnected from the primary volumes and be able to see only
secondary volumes (that is, have non-uniform volume access), it may be necessary to disable the
path_management policy for those volume groups until the uniform cluster is re-established.
"
My experience so far is that when the switchover occurred, the host's paths don't update, however, not all of the paths are active like what the manual describes.